The K 165 Uno system features a 24 mm (0.9ˈ) diaphragm Neodymium tweeter with PEI dome, for a brilliant reproduction of high frequencies in a compact size. The annular acoustic lens is optimized for exceptional off-axis performance, ensuring an accurate stereo image. The 6.5” woofers features a pressed-paper cone with foam surround, for high SPL and solid bass. The 25 mm(1ˈ) woofer voice coil driven by a high-flux density ferrite magnet offers a highly dynamic power handling for a powerful undistorted sound. The 6dB/Oct crossover is integrated on the tweeter wiring for an easy OEM upgrade.
A pair of front or rear door car speaker adapter panels for 165mm speakers.
These MDF panels allow you replace the cars original speakers with new improved quality aftermarket speakers.
Fits the following vehicle front or rear doors:
Isuzu
D Max, Rear door only
Technical data:
Loudspeaker: 165 mm
Installation cutout: 148 mm
Ring height: 24.5 mm
A pair of Speaker adapter cables used to connect after market speakers to the original loom on Isuzu D-Max.
Fits the following vehicle models:
Isuzu
D Max (RT50) (2012 – 2020)
Designed to fit any 165mm speaker, this pair of adjustable speaker baffles creates a flexible seal around the back of the speakers, protecting them from water that gets inside doors and interior panels. Additionally it provides a barrier stopping interference between sound from the front and rear of the speakers having a negative effect on sound quality.
- Made from silicone with egg wave foam rear
- Flexible and foldable for a perfect fit.
- Better sealing for better sound
- Helps focus sound into the cabin and eliminate interference.
- Seals the speaker against the interior panel and the self adhesive foam pad sound proofs and lessens rattling of trim.
- Protects the speakers from water ingress
- suitable for 165mm / 6.5 inch speakers
- Sold as a Pair (includes 2 x Self Adhesive Wave Foam Pad)
Pack of nuts, bolts, washers and terminals for fitting a pair of speakers and speaker rings.
Contains the following
12x M5 bolts
12x M5 flanged nuts
8x M5 Stainless Steel Washers
4x 2.8mm Insulated Spade Terminals
4x 4.8mm Insulated Spade Terminals
Nuts and bolts are for fitting the speaker rings to the doors if the original were rivetted.
Washers can be placed behind the screws holding the speaker in place to spread the load and stop the speaker dropping from slightly undersized screws.
Insulted crimp terminals can be used when no speaker adapter cable is available. The original speaker connector would need to be cut off, wire ends stripped and the terminals crimped in place. These are for speakers with 0.8mm tab connections. They will not be needed for speakers with screw type fittings.
Citroen, Peugeot, Toyota,Vauxhall,Nissan Front Rear Door Speaker Fitting Kit Hertz UNO K165 - 16.5cm 2-Way Component Speakers 300W£130.00
